Automon mentioned on Scantool.net
Scantool.net are one of the biggest distributors of PC-based scan tools based on the ELM327 IC.
They mentioned my project on their website – Thanks! The article is located at
http://www.scantool.net/scantool/news/2009/may/07/automon/
I would like to thank Vitaliy Maksimov from Scantool.net – he kindly arranged the shipment of an ElmScan 5 USB for my project. He also helped me with technical issues – much appreciated!
Their website address is: http://www.scantool.net/
4 Comments to Automon mentioned on Scantool.net
Leave a Reply
You must be logged in to post a comment.
Tags
Archives
| M | T | W | T | F | S | S |
|---|---|---|---|---|---|---|
| « Nov | ||||||
| 1 | ||||||
| 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| 9 | 10 | 11 | 12 | 13 | 14 | 15 |
| 16 | 17 | 18 | 19 | 20 | 21 | 22 |
| 23 | 24 | 25 | 26 | 27 | 28 | 29 |
| 30 | ||||||
Blogroll
QT Programming
Single Board Computers (SBCs)
Recent Comments
- Mark Mikaelsen on QT and QExtSerialPort
- Mark Mikaelsen on QT and QExtSerialPort
- Donal on QT and QExtSerialPort
- Dmitriy on QT and QExtSerialPort
- Donal on QT and QExtSerialPort
Hi Donal,
I have been developing using TS7390 for the last 4 months and although i have just found your blog just today, i am surprised to see that we have encountered the same problems using the board and QT. One of the problems is the touchscreen. I have followed your blog to compile and install the tslib but when calibrating, ts_calibrate reports that the selected device is not a touchscreen.
I have checked and double checked the environment variables and i am sure they are the same as in your blog. ts.conf is also properly configured.
Have you encountered such a problem. or can you assist?
regards
Patrick
Hi Patrick,
I think I had that problem at some stage, when I attempted to re do everything again.
I’ve a compiled version of tslib that should run located at: automon.donaloconnor.net/files/tslib.zip
Maybe you’d like to try this first. I’ve also included the config file.
Make sure to delete the auto generated calibration file before re running ts_calibrate
Have you also set full permissions on the /dev/fb0 device.
Regards,
Donal
Hi Donal,
Thank you very much. Your library worked very well.
I just wonder why my compilation didn’t work. maybe it was from a different version.
Regards,
Patrick
Hi Patrick,
That’s good news. Strange alright, but I did have the same problem myself. Think I just resorted to this solution as well as I had it backed up
Enjoy.
Donal